DBPapers
Home > OIL AND GAS EXPLORATION > OIL AND GAS EXPLORATION

OIL AND GAS EXPLORATION

- New methods and technologies in petroleum geology
- Characterization of unconventional gas reservoirs
- Three-dimensional visualization of the porous rock structures
- Directional and horizontal drilling and tomography methods
- Underground gas storing and reservoir modeling
- Refining, oil and gas trade and marketing
- Environment protection in petroleum industry. Capacity building, environmental impact assessment and monitoring in oil and gas developments

Articles in this section


INVESTIGATION OF PHYSICAL AND MECHANICAL PROPERTIES OF ASPHALT MIXTURES MODIFIED BY ADHESIVE ADDITIVE (Papers SGEM2018)

I. I. Mukhamatdinov, A. F. Kemalov, P. S. Fakhretdinov
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Asphalt concrete correspond to dispersive strengthened composition material, in which organic matrix-bitumen takes over all the load and forces. The structure and properties of asphalt concrete are determined mainly by the phase and physical state of the organic matrix-bitumen. In (...)


INVESTIGATION OF RHEOLOGICAL PROPERTIES OF ADDITIVES WITH NANOCOMPONENT DURING THE TRANSPORTATION OF VISCOUS OIL (Papers SGEM2018)

N. M. Khasanova, E. V. Kharitonov, A. V. Sharifullin, L. R. Baibekova
Thursday 11 October 2018 by Libadmin2018
ABSTRACT This work is investigation of the rheological properties of the developed additive based on polymer - sevylene with the addition of nanostructure alumina particles were studied. The regularities of the decrease in the dynamic viscosity at the temperature range from 20 to -10° In the (...)


LOW BOTTOM-HOLE PRESSURE IMPACT ON PRODUCTION FROM CARBONIFEROUS DEPOSITS IN REPUBLIC OF TATARSTAN (Papers SGEM2018)

I. A. Guskova, L. I. Garipova, I. I. Mannanov
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The issue concerning reasoning and evaluating the optimal bottom-hole pressures is considered to be one of the challenges in mature oilfield development. Bottom hole pressure optimization is a relevant and researchable problem, and it requires a nuanced approach to a solution (...)


MAGNETIC IMPACT DAMPENING OF VIBRATIONS IN TECHNOLOGICAL EQUIPMENT FOR OIL AND GAS PRODUCTION (Papers SGEM2018)

V. Bukhtoyarov, K. Bashmur, I. Nashivanov, E. Petrovsky, V. Tynchenko
Thursday 11 October 2018 by Libadmin2018
ABSTRACT In the paper a magneto-impact approach for vibration damping of technological machines used in oil and gas production is proposed. It is suggested that there are specific features of magnetically impacted vibration dampening that favorably distinguish it from the classical (...)


METHOD FOR TESTING COMPOUNDS OF EXPLOSION-PROOF ELECTRICAL EQUIPMENT WITH ENCAPSULATION TYPE OF PROTECTION (Papers SGEM2018)

C. Colda, S. Burian, T. Csaszar, M. Darie, D. Grecea
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The use of electrical energy in potentially explosive atmospheres involves various particularities, fact for which there have been raised a lot of issues concerning the design, construction and exploitation of electrical equipment and installations intended to be used in these (...)


MICRO-SCALE PREFORMED PARTICLE GEL/SURFACTANT EOR PROCESS FOR HIGH TEMPERATURE AND HARD BRINE RESERVOIR (Papers SGEM2018)

W. Pu, M. A. Varfolomeev, Ch. Yuan, T. Tan
Thursday 11 October 2018 by Libadmin2018
ABSTRACT X reservoir is a high temperature (97 ℃), high salinity (TDS 204600 mg/L, divalent cation 11480.34 mg/L), middle-low permeability sandstone reservoir located in Tarim Basin (China). Serious vertical and lateral heterogeneity of formations resulted in the injection water channeling from (...)


MINIMIZING BOTTOMHOLE PRESSURE LOSSES USING TSE – TOTAL SPECIFIC ENERGY – A NEW INDICATOR OF DRILLING EFFICIENCY (Papers SGEM2018)

R. Wisniowski, P. Toczek
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The aim of the project is to determine the optimum geometry and different kinds of nozzles location on the drilling tools face. The optimum geometry and its proper arrangement will allow the maximum use of specific mechanical energy drilling through its reduction and minimizing (...)


MODELLING OF EXPLOSION RISK AREAS IN A FUNCTION OF TERRAIN TOPOGRAPHY, WEATHER CONDITIONS AND CHEMICAL COMPOSITION FOR A GAS MIXTURE OF PROPANE-BUTANE TYPE (Papers SGEM2018)

A. Kalbarczyk-Jedynak
Thursday 11 October 2018 by Libadmin2018
ABSTRACT At the age of an increasing demand for energy we reach to an ever wider range of substances giving a possibility of its generation. A constant need for energy supplies is so strong that we are not prevented by the danger related to the storage or transport of such substances. (...)


MODERN CONSTRUCTION TECHNOLOGIES OF GAS PIPELINES AND OIL PIPELINES (Papers SGEM2018)

J. Ziaja, R. Wisniowski, A. Jamrozik, D. Knez
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Natural gas and oil have been unquestionably the most important energy resources in the world for years. Unfortunately, the occurrence of oil-based regions does not coincide with the main areas of oil and gas consumption. Therefore, it is necessary to transport hydrocarbons over very (...)


MUTUAL EFFECTS OF SARA FRACTIONS ON THE OXIDATION BEHAVIOR CHARACTERIZED BY DIFFERENTIAL SCANNING CALORIMETER (DSC) (Papers SGEM2018)

Ch. Yuan, M. A. Varfolomeev, R. Khaliullin, A. A. Eskin, R. N. Nagrimanov
Thursday 11 October 2018 by Libadmin2018
ABSTRACT In-situ combustion process has been proven to be an effective enhanced oil recovery (EOR) method for heavy oils. However, until now, the in-situ combustion is still not widely used as steam injection is. The main reason that limits the wide application of in-situ combustion process is (...)


Home | Contact | Site Map | Site statistics | Visitors : 353063

Follow site activity en  Follow site activity OIL AND GAS EXPLORATION   ?

CrossRef Member    Indexed in ISI Web Of Knowledge   Indexed in ISI Web Of Knowledge
   

© Copyright 2001 International Multidisciplinary Scientific GeoConference & EXPO SGEM. All Rights Reserved.

Creative Commons License