DBPapers
Home > RECYCLING > RECYCLING

RECYCLING

- Recycling of industrial wastes (metallurgical, mechanical, chemical, of a power plant, after mining and mineral processing activities, food industry)
- Recycling of municipal refuse, hospital, agricultural, radioactive wastes
- Recycling of spoils and demolition waste
- Recycling of car wrecks
- Recycling of plastics
- Recycling of other wastes
- Introducing new technologies for electronic processing
- Alternative processing of tail wastes with the aim of maximum of recycling and/or reclaiming

Articles in this section


EVALUATION OF ECONOMIC RETURN ON INVESTMENT TO NEW PRODUCTION TECHNOLOGY (Papers SGEM2018)

K. Culkova, J. Kosco, J. Spisak, I. Kanuchova, E. Mihalikova
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Product manufacturing continuously increases despite of complicated relations and unstable world economics. Various forecasts of development in industry show that in future the consumption should not decrease; on the contrary, it should slightly increase. This happens even despite of (...)


EVALUATION OF THE ELECTROWASTE MANAGEMENT SYSTEM IN POLAND (Papers SGEM2018)

B. Bialecka, K. Rudzinski
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Management of used electrical and electronic waste is a huge problem both on a local and global scale. The mass of collected electrowaste in Poland currently reaches approximately 5 kg per one inhabitant, and by 2021 it is to increase to 11 kg. According to estimates, only ca 30-40% (...)


FACTORS CONTRIBUTING TO TECHNOSPHERE (Papers SGEM2018)

A.A. Lipaev, L.M. Alekseeva, R.H. Sabirova
Thursday 11 October 2018 by Libadmin2018
ABSTRACT One of the factors looked upon as an intrinsic constituent contributing to the technosphere as a true phenomenon in the development of the humanity is industrialization. Being powered by fossil fuels, it greatly accelerated urbanization and enabled enormous development in agriculture. (...)


HYDRAULICITY OF METALLURGICAL SLAGS (Papers SGEM2018)

A. Pribulova, P. Futas, D. Baricova, J. Petrik
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The property that influences the binding properties of slag is its hydraulicity. The term “hydraulicity“ is now used internationally to describe cements and other binders that set and harden as a result of chemical reactions with water and continue to harden even if subsequently placed (...)


INVESTIGATION OF THE EFFECT OF TAILINGS CHARACTERISTICS ON PASTE BACKFILL PROPERTIES (Papers SGEM2018)

F. Cihangir, A. Kesimal, T. Yilmaz, E. Koc, Y. Akyol
Thursday 11 October 2018 by Libadmin2018
ABSTRACT In this study, the effect of physical, chemical and mineralogical properties of mine tailings on the microstructural, mechanical and durability properties of cemented paste backfill (CPB) samples prepared with normal Portland cement were investigated. Depending on the characteristics (...)


INVESTIGATION OF THE POTENTIAL USE OF DAM TAILINGS AS PASTE BACKFILL MATERIAL IN A COPPER MINE (Papers SGEM2018)

B. Ercikdi
Thursday 11 October 2018 by Libadmin2018
ABSTRACT In this study, the potential use of dam tailings (DT15 m., DT40 m., DT65 m.) of a copper mine for paste backfill material was investigated. Cemented paste backfill (CPB) samples were subjected to the uniaxial compressive strength (UCS) test at 7-14-28-56-90-180 days of curing ages. A (...)


ANALYSIS OF PHYSICOCHEMICAL PROPERTIES AND MORPHOLOGY OF FUEL MIXTURES BASED ON DIESEL AND PYROLYSIS OIL (Papers SGEM2018)

R. JASIEWICZ, M. SZMUKALA
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Decreasing fossil fuel resources and the growing attention to environmental causes increased interest in alternative fuels. Currently as a liquid alternative fuels apply: methanol, ethanol, biodiesel (FAME), dimethyl ether (DME). They can be used directly, or as components of mixtures (...)


ASSESSMENT OF PACKAGING WASTE RECYCLING IN POLAND (Papers SGEM2018)

M. Alwaeli
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Packaging waste are one of fastest growing waste streams. Trends in waste generation show an increase in the volumes of waste produced in most countries and it is clear that the trend will continue. Currently, the management of packaging waste represents a major economic and (...)


CHALLENGES IN DEVELOPING DECISION SYSTEMS SUPPORTING WASTEWATER MANAGEMENT IN A CONTEXT OF CIRCULAR ECONOMY (Papers SGEM2018)

K. Jaderko
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Wastewater management in Poland has a large potential for growth, however, like other countries has to face the new challenges related to the implementation of the circular economy. Innovative wastewater and sewage sludge treatment technologies can bring ecological, social and (...)


COMPARATIVE ANALYSIS OF PHYSICOCHEMICAL PARAMETERS OF MUNICIPAL WASTE SLUDGE IN THE LIGHT OF ORGANIC RECYCLING (Papers SGEM2018)

M. Czop, A. Petryk
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Municipal waste sludge belongs to a specific type of wastes formed in a process of mechanical, biological and chemical treatment of wastes. The sewage sludge, due to its variable content, constitutes a big problem with respect to optimum and safe sludge management. There is no single (...)


Home | Contact | Site Map | Site statistics | Visitors : 353063

Follow site activity en  Follow site activity RECYCLING   ?

CrossRef Member    Indexed in ISI Web Of Knowledge   Indexed in ISI Web Of Knowledge
   

© Copyright 2001 International Multidisciplinary Scientific GeoConference & EXPO SGEM. All Rights Reserved.

Creative Commons License