DBPapers
Home > GREEN BUILDINGS TECHNOLOGIES AND MATERIALS > GREEN BUILDINGS TECHNOLOGIES AND MATERIALS

GREEN BUILDINGS TECHNOLOGIES AND MATERIALS

- Ecological, inorganic and regenerative building materials. Low carbon buildings.
- Recycling technologies of the building materials waste.
- Low power consumption technologies of the building materials and construction production.
- Insulation technologies and thermal insulation building materials
- Renewable energy materials in construction production.
- Ecological building and environmental planning. New building materials.
- Energy-saving and environmental protection technologies in architectural planning, design, construction applications and rebuilt processes.
- Control technologies of construction energy.
- Agricultural by product used in constructions.
- Monitoring and Control technologies in construction production.

Articles in this section


HYBRID JOINT TESTING PROGRAM. TESTING OF COMPONENT MATERIALS (Papers SGEM2018)

C. Campian, M. Pop, N. Chira, K. Zoltan
Wednesday 19 December 2018 by Libadmin2018
ABSTRACT A new joint configuration system has been developed to achieve a higher strength and ductility. The joint system consist of a reinforced concrete wall and a composite steel-concrete beam. The study aims for an experimental and a numerical part in a FEM program Abaqus 6.13. The program (...)


IMPACT OF INITIATOR PLACEMENT ON IGNITION OF THE VERTICALLY POSITIONED ELECTRICAL CABLE (Papers SGEM2018)

P. Rantuch, T. Stefko, J. Martinka, I. Wachter, H. Kobeticova
Wednesday 19 December 2018 by Libadmin2018
ABSTRACT The cone heater is one of the primary sources of radiant heat in the field of fire protection. It is increasingly used not only for measurements related to building materials but also for other flammable objects, that may be exposed to heat radiation during their lifetime or during a (...)


ASSESSMENT OF WORK ACCIDENTS IN HIGHWAY, STREET AND BRIDGE CONSTRUCTION (Papers SGEM2018)

A. Bilim, O. N. Celik
Wednesday 19 December 2018 by Libadmin2018
ABSTRACT Occupational health and safety is an important work discipline that must be included in the working life. Especially, developed countries have been able to place this discipline in working life, while developing countries have still problems. These problems take place both in terms of (...)


CONTEMPORARY TIMBER BUILDINGS (Papers SGEM2018)

J. Barnas
Wednesday 19 December 2018 by Libadmin2018
ABSTRACT The article presents problems associated with attempts at introducing renewable materials into general use in architecture, with a particular focus on timber. The full implementation of this process will make it possible to significantly lower waste production as a result of the (...)


A STUDY ON THE POSSIBLE USE OF SANDSTONE DUST AS FINE AGGREGATE IN MORTAR MIX DESIGN (Papers SGEM2018)

Z. Pavlik, M.Zaleska, J.Pokorny, M. Pavlíkova, O. Jankovsky
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The stone dust coming from stone processing plant located in Ostroměř, Czech Republic, was examined in the presented paper as an alternative recyclable environment-friendly material which can be effectively being used in construction as partial replacement of natural sand. The tested (...)


ANALYSIS OF THE EFFICIENCY OF NON-TRADITIONAL THERMAL INSULATION MATERIALS (Papers SGEM2018)

S. Gendelis, A. Jakovics
Thursday 11 October 2018 by Libadmin2018
ABSTRACT The aim of this research is to analyse the thermal properties of different non-traditional insulation materials with low thermal conductivity and light weight that are made from Latvian local raw materials and are “green” or are innovative and advanced materials. The studied (...)


ANTIFUNGAL EFFICIENCY OF SLAG BASED CEMENT COMPOSITES (Papers SGEM2018)

M. Smolakova, A. Estokova, V. Vaclavik
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Blast furnace slag (BFS) is used for preparation of common cements, sulfate-resisting and chemical-resisting cements and cement mortars. Using BFS as a concrete or mortar addition results in several advantageous properties such as high resistance to acid attack (sulphuric, nitric (...)


APPLICATION OF THE CONFOCAL SCANNING MICROSCOPE LEXT OLS3000 FOR SETTING THE POROSITY OF MATERIALS (Papers SGEM2018)

M. Kostelecka
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Porosity belongs to basic characteristics of building materials. It is a characteristic of solid or semi-rigid materials, which contain a lot of tiny and uniformly distributed cavities or holes of various shape and origin. Porosity decreases specific weight of materials, increases (...)


APPLICATION OF WHEAT STRAW ASH IN PRODUCTION OF ALKALI-ACTIVATED CONSTRUCTION COMPOSITES (Papers SGEM2018)

J. Pokorny, M. Pavlikova, O. Jankovsky, Z. Pavlik
Thursday 11 October 2018 by Libadmin2018
ABSTRACT We focused at the presented study at the valorization of biomass ash as filler in the design and development of new eco-efficient alkali-activated geopolymers. Since coal fly ash is one of the main precursors used for alkali-activated geopolymer production, this research examines the (...)


ASSESSING DAYLIGHT IN DIFFICULT TO ILLUMINATE SPACES (Papers SGEM2018)

I. Skotnicova, B. Chudikova
Thursday 11 October 2018 by Libadmin2018
ABSTRACT Building is constantly heading for the development of new technologies, better materials and reduction of energy consumption, however daylighting remains an essential factor that considerably affects the interior of buildings and it cannot be technologically improved or replaced. The (...)


Home | Contact | Site Map | Site statistics | Visitors : 353063

Follow site activity en  Follow site activity GREEN BUILDINGS TECHNOLOGIES AND MATERIALS   ?

CrossRef Member    Indexed in ISI Web Of Knowledge   Indexed in ISI Web Of Knowledge
   

© Copyright 2001 International Multidisciplinary Scientific GeoConference & EXPO SGEM. All Rights Reserved.

Creative Commons License